Differences

This shows you the differences between two versions of the page.

--- modding:charger [2020/04/23 09:19] – [Idea] xanathon
+++ modding:charger [2020/04/23 09:22] (current) – xanathon
@@ Line 36: / Line 36: @@
 This seems to work better, but not always, sometimes Vector tries to drive diagonal onto the charger and seems not so "see" the stripe. So I guess this needs some more experiments but should definitely be solvable. If you have any insights or suggestions for improvement, please feel free to comment this page.
-Another possibility may be to print in black PLA instead of white and just add a white stripe.
+Another possibility may be to print in black PLA instead of white and just add a white stripe (but the white filament was already in the machine so I used it).
 I also glued the rubber pads from Cozmo's charger to the underside of the new one to prevent sliding and that works quite fine, but depending on how slick the surface is you use this on you may need to put additional weights into the new charger to make it a little heavier. But there should be room enough for that.
@@ Line 49: / Line 49: @@
 Have fun printing,
 Xanathon
+~~DISCUSSION~~

TheDroidYouAreLookingFor